Skip to content

Gqeberha

067 397 3341
Pools · Gqeberha

Swimming Pool Maintenance and Repairs

The pool that went green while you were away, and the pump that started screaming.

A pool is a small water plant that only works while the pump is running. Green water gets blamed on the chemicals, and most of the time the chemicals are innocent. If water is not moving through the filter, no amount of chlorine keeps up with a coastal summer, and the algae wins in days rather than weeks.

So the visit starts at the equipment rather than at the water. Cleaning, the pump and its motor, the pipes, and the filter. Those four are what decide whether a pool stays clear, and they are what gets looked at first.

Close up of a pressure gauge, ball valve and pipework on a pool pump manifold

Typical price

R600 to R2,500labour

Send photos of the pool, the pump and the filter, and you get a price per job. A cleaning visit, a pump seal and a sand change are three different prices and the photos tell them apart. If the pump is seized or the filter body is cracked, that gets said before anything is stripped down.

Every job is quoted at a fixed price before work starts, so there is no hourly rate and no meter running. Labour only. Materials and fittings are quoted separately and approved by you before anything is bought.

How pricing works

Typical jobs

What this usually turns into

  • Pool vacuumed, brushed, skimmed and the baskets cleaned1 to 2 hrs
  • Pump stripped, seals, O rings and impeller checked and replaced1 to 2 hrs
  • Pump or motor unit replaced like for like1.5 to 2 hrs
  • Filter sand or media replaced, internals checked while it is open1.5 to 2 hrs
  • Suction or return pipe leak repaired where the pipe is reachable2 to 3 hrs
  • Filter, pump and flow checked over, with a straight report on what is next1 hr

Times are on site, not including travel, and they are a guide rather than a promise: a job that reveals something once it is open takes longer, and you hear about it before it carries on. Every job is quoted at a fixed price before work starts, so adding to the list changes the quote rather than running up a meter.

What is covered

Included in the visit

  • Vacuuming, brushing, skimming and emptying the pump and skimmer baskets
  • The filter cleaned, backwashed and the pressure gauge read
  • Pump and motor faults: mechanical seals, O rings, impellers and dry bearings
  • Pump and motor units replaced like for like
  • Suction and return pipe repairs where the pipe can be reached without breaking up paving
  • Filter sand and media replaced, with the laterals and internals looked at while the filter is open

Where the line is

Where this stops, in plain terms. Motors that need rewinding, capacitors, wiring, timers and anything on the DB board are an electrician's work, and so are pool lights and chlorinator controllers. Pipework buried under paving or a slab needs leak detection gear and an excavator before anyone can repair it, so that goes to a pool specialist. Pool surfaces are their own trade as well: marbelite, fibreglass, liners, structural cracks, heaters and heat pumps are all pool renovation work. Those get referred on rather than half done, and you hear it before money is spent.

Straight answers

Pool maintenance questions

The things people ask about this job before booking it.
My pool is green. Is that the chemicals or the pump?

Usually the pump side, and the chemicals get the blame. Green water means algae is growing faster than the chlorine can kill it, and the reason the chlorine cannot keep up is almost always that water is not moving through the filter properly: a choked filter, a blocked pump basket, an impeller full of leaves, or a pump running hot and cutting out. Anything that stops circulation shows up as a green pool within days. So the first visit goes at the equipment and the flow, and if the water still needs treating after that, you get told exactly what it needs.

Is it worth repairing a pool pump motor, or should it be replaced?

It depends on what failed, and the honest answer is that some failures are worth fixing and some are money spent on a dying motor. Worn mechanical seals, perished O rings, a blocked or damaged impeller and dry bearings are all worth repairing, and a seal that has started weeping is worth doing before it takes the motor with it. A burnt winding, a seized shaft or a cracked housing is a replacement rather than a repair. Either way you get told which one you are looking at before anything is stripped down.

How often does the filter sand need replacing?

Sand does not wear out so much as it gums up and channels, and the tell is pressure. If the filter pressure will not settle back down after a backwash, or the pool will not clear no matter how long the pump runs, the sand is the first thing worth opening up. In a leafy coastal garden it gets there sooner than most owners expect. The pressure and the flow get checked first, and if a sand change is not the answer you hear that rather than being sold one.

Can you fix a pipe leak without digging up the paving?

If the leak is above ground, usually yes: a weeping union, a cracked fitting, a leaking valve on the pump or filter, or a pipe that has come apart at the pump. A buried line is a different job. Finding a leak under paving or a slab needs detection equipment and then breaking the surface, which is a pool specialist's work rather than a handyman's. Water disappearing slowly with no wet patch anywhere is usually a buried line, and that gets referred rather than guessed at.

Book pool maintenance in Gqeberha

Send the job with a photo or two and you get an honest price and a sensible slot. Add anything else from your list while you are at it.

WhatsApp your listCall 067 397 3341

No price is agreed until you approve it

Call nowGet a quote