Every year the same thing happens in the second week of December. A pool that has been ignored since April gets shocked, brushed twice, and pronounced ready, and then stays cloudy for the whole holiday while the family swims in it anyway.
Recovery is not a day's work. It is a sequence, and the sequence takes weeks because water chemistry and filtration both work on time rather than on effort. Starting in the first half of November is what makes December easy.
Why six weeks
Three separate processes have to run, and they run in order.
The chemistry has to be corrected, which means the pH, alkalinity and stabiliser levels come right before chlorine can do its job. Chlorine poured into water with the wrong pH mostly wastes itself.
The filter has to be able to clear what the chlorine kills. Dead algae is fine debris, and fine debris is a filter's job. A filter with spent media will not clear a pool no matter how much chemical goes in.
The water has to be circulated. A pool that has been standing for months has dead spots, and the pump needs to run long enough to turn the volume over repeatedly.
None of that happens in a day, and none of it can be skipped by using more chlorine.
Week one: assess and correct
Start with the water, not with the bottle.
Test the pH, total alkalinity, stabiliser and chlorine. Correct the alkalinity first, then the pH, then worry about chlorine. This is the order that saves money, because every other reading depends on those two being right.
Then look at the equipment. Is the pump running? Is the pressure gauge reading? Is the water level at the skimmer? Is the basket clear? Is the filter set to filter rather than to waste or backwash?
Deal with anything mechanical now, because a pool cannot be recovered without circulation, and parts take time to arrive.
Why the chemistry order matters
Chlorine gets blamed for a lot that is not its fault. It works within a narrow pH band, and if the pH is high the same dose does a fraction of the work. That is why a pool can be "shocked" repeatedly and stay green.
Alkalinity comes first because it stabilises the pH. Get alkalinity right and the pH stops swinging, which matters in a pool that has been standing for months. Then adjust pH into the working range. Then chlorine will do what it is supposed to do.
Stabiliser is the third variable and the one most people never test. It protects chlorine from sunlight, and too much of it locks the chlorine up so it stops working. A pool that has been dosed with stabilised chlorine tablets for years can end up with more stabiliser than it needs, and the only real fix is dilution, which means partly draining and refilling.
Test it before you spend money on chemicals. It is a cheap test and it explains a lot of stubborn pools.
What not to do
Four shortcuts that make a pool worse.
Do not shock a pool and then leave the pump off. The chlorine needs circulation to reach the algae, and a pool that sits still after a shock grows it back.
Do not backwash a sand filter every day "because it is dirty". You are removing the water and the fines and never letting the bed do its job.
Do not add flocculant and skip the vacuum. Flocculant drops debris to the floor, and if it is not vacuumed to waste it just sits there.
Do not swim in a pool that has just been shocked until the chlorine has come back down. That one is not about water clarity.
Week two: filtration
This is the week that most people skip, and it is why their pool stays cloudy.
If the filter pressure sits high after a backwash, or climbs again within days, the media is spent and needs replacing. That is the single highest value job on a neglected pool, and it is why our published range for filter sand or media is R900 to R2,200. A filter with old media is a pump running for nothing.
Run the pump longer than usual this week. Eight hours a day is a reasonable working figure for a residential pool in recovery, and a pool that has been standing needs the turnovers.
Weeks three and four: the green pool
Now the chemical work, and it has to be patient.
Brush the walls and floor before shocking anything. Algae holds onto surfaces, and chlorine cannot kill what it cannot reach. Brushing is the part that people leave out, and it is why a shocked pool goes green again within a week.
Then shock according to the volume and the state of the water, keep the pump running, and clean the filter as the pressure climbs. Dead algae loads a filter fast, which is why the filter has to be checked daily during recovery rather than weekly.
Expect the water to go from green to milky blue before it goes clear. Milky is progress: the algae is dead and the filter is removing it.
Week five: equipment
By now the water is clear or close to it, and the pool is being used. This is the week to check the things that fail under load.
The pump seal, O-rings and impeller are the usual casualties of a season of running with a dirty basket. Our published range for replacing them is R900 to R1,800, and doing it before December means doing it without the pump being off while people want to swim.
Check the multiport valve for leaks at the waste port, the pressure gauge, the skimmer basket and the weir flap. Then check the pump lid O-ring, which costs almost nothing and is the most common cause of a pump losing prime.
Week six: the routine that keeps it clear
The last week is not work, it is habit.
Skim the surface daily, empty the basket, brush the walls once a week, backwash when the pressure says so rather than on a calendar, and keep the chlorine in range. That routine is what carries the pool through December.
A pool that is cleaned, vacuumed and brushed costs R350 to R800 with us. Weekly servicing through the holidays is cheaper than one recovery in January.
What to buy before you start
Buy the test kit before the chemicals, and buy the test kit that gives you alkalinity and stabiliser as well as pH and chlorine. A strip that only reads pH and chlorine will not tell you why the chlorine is not working.
Then buy in this order: alkalinity adjuster, pH adjuster, chlorine, and only then anything for algae. Most people buy the algaecide first because it is the one with the picture of a green pool on it, and then wonder why it did nothing.
Skip the pool shop's full recovery package unless it is priced per volume and itemised. Two pools of the same size need different treatment, and a box of bottles is a guess.
If you are starting late
It can still be done in three weeks, with caveats.
Prioritise in this order: correct the chemistry, fix the filter, then shock and brush. Skip the equipment checks if you have to, and accept that a pump seal may fail in December. What you cannot skip is the filtration, because that is the machine doing the actual clearing.
If the media is spent and you start late, replace it anyway. A late start with a working filter beats an early start with a dead one.
What this costs, in one place
- Pool cleaned, vacuumed and brushed: R350 to R800
- Filter sand or media replaced: R900 to R2,200
- Pool pump seal, O-rings or impeller replaced: R900 to R1,800
Materials and chemicals are quoted separately and approved before anything is bought.
Book the November slot
WhatsApp 067 397 3341 with the pool volume if you know it, and a photo of the water and the filter label. We will tell you which of the six weeks you are in and what it needs.
November is the quiet month for pools and the expensive one for pumps. Getting the work done now is how you spend December in the water instead of standing next to it holding a net.
Got a list that needs working through?
Send it on WhatsApp with a photo or two and you get a price back, before anything is booked.
Send the list