Skip to content

Gqeberha

067 397 3341
Doors

Why your door sticks in winter, and why sanding it makes next winter worse

6 min read · Gqeberha

A door sticks in winter because the timber has taken on moisture and swollen, not because the door has grown. Sanding the edge clears it for this winter, and it also removes the very material that will swell next winter, so the door comes back tighter and starts binding earlier than it did before.

Doors in Gqeberha and Port Elizabeth move with the seasons just like doors anywhere else, and the older the door, the more it moves. If yours is catching at the top, dragging on the floor or rubbing the frame down one side, what you do about it depends on which of three things is actually happening. Two of those three are not the door at all, and they are the two most people miss.

What a wet and dry cycle does to a timber door

Timber takes on moisture out of the air when humidity is high and gives it back when the air dries out, and it moves mostly across its width and thickness rather than along its length. A wet winter here means damp air, houses closed up against the weather and no sun drying anything out, so a door that was comfortable in summer swells just enough to catch on the frame. When spring dries the air, the door shrinks back and the problem appears to fix itself. That is the whole cycle, and it is why a door that stuck last winter is almost certain to stick again this winter. A door that fits perfectly in a dry March can be catching by July with nothing changing except the air, and no door settles down and learns to cope on its own.

Where the door binds, and what that tells you

  • Catching at the top corner on the latch side: usually swelling across the width of the door, often with a frame that has shifted slightly as well
  • Dragging on the floor: swelling at the bottom edge, or a door that was already sitting close to the floor before it swelled
  • Rubbing along one whole side: swelling plus a frame that is slightly out of square, which is common in older houses
  • Binding only when it is closed rather than as it swings: the latch or the strike plate rather than the door
  • Loose while it swings but tight once shut: a dropped hinge, which imitates a swelling door very convincingly

Why sanding works this year and fails next year

Sanding the edge is the fix most people reach for, and it does work on the day. The binding edge gets taken back, the door swings freely and the job looks finished. The trouble is what has been removed. A door only swells as far as its clearance allows, and sanding lowers the point at which it starts to catch. Next winter the same weather arrives, the door swells the same amount and there is less room than before, so it binds sooner and harder. Sanding again buys another year and makes the year after that worse. There is also a limit to how many times it can be done, and that limit arrives sooner on a hollow core door than on a solid one.

Do that over a few winters and you are left with a door that has visibly lost its edge, a gap that lets in draughts and dust in summer, and a problem that is now partly of your own making. The edge is also the part of a door that shows most once it has been cut back, particularly on a painted door where the cut breaks the line of the face.

The fix that lasts: adjust the hinges and the frame

The better approach is to move the door rather than to reduce it. In most cases a sticking door is being held slightly out of line by its hinges, or by a frame that has moved, and correcting that gives the door the clearance it needs without losing any timber. A hinge can be packed or reset, screws that have lost their grip in the frame can be reworked, a worn hinge can be replaced and a frame that is out of square can be adjusted. It is a slower job than a quick sand, and it holds up far better across the seasons.

There is a real case for planing, and it is the case where the door genuinely is too big for its opening: a replacement door that was never fitted properly, a door that swelled after water got into it, or a floor that has been lifted or levelled since the door went in. Where planing is the answer, the cut edge gets sealed or repainted afterwards, because a bare edge takes on moisture faster than a finished one and starts the whole cycle going again.

Older doors, older suburbs and the coastal difference

Newer doors are usually steadier. Engineered cores and modern finishes cope with moisture better than a solid timber door made decades ago, and the frames they hang in are more often square. Older housing stock is a different matter. Homes around Newton Park, Charlo and Mount Croix mostly date from a time when doors were solid timber and frames were built in place, and a door that has hung in the same frame ever since has had a great many winters to move. When somebody in those suburbs calls about a door that sticks every winter, the answer is usually the door and the frame together rather than one or the other.

Coastal homes have their own version of the problem. Salt air strips the plating off cheap hinges and eats the screws that hold them, so a door near the sea is more likely to drop than to swell, and the fix is a set of hinges that will survive the air rather than an adjustment to the door itself.

What it costs

  • Sticking door adjusted: R280 to R500
  • Door planed and refitted: R400 to R650
  • Hinges replaced: R200 to R380

Door work is quoted as a fixed price per job, and those are the published ranges. The gap between the first two lines is the amount of work rather than a markup, because adjusting hinges is quicker than taking a door off, planing it, refitting it and making good the finish. Hinges and any other fittings are quoted separately and approved before anything is bought. If the job turns out to be a frame problem rather than a door problem, that changes the price, and it gets discussed before work starts rather than added afterwards.

If your door only sticks in the wet months and swings freely again by October, hold off on the sandpaper. A seasonal door is a door that needs its hinges and its frame looked at, and every sanding shortens the time you have to fix it properly.

The short version

A door that sticks in winter has swollen with moisture, so sanding the edge clears it now and brings the problem back sooner next year. Check the hinges and the frame first, because a door that has dropped or a frame that has moved imitates a swelling door almost exactly, and correcting either of those removes no timber at all.

Send a photo of the door and the gap along its top edge on WhatsApp, with a line about what it rubs against, and you get a fixed price for the adjustment or the refit.

Got a list that needs working through?

Send it on WhatsApp with a photo or two and you get a price back, before anything is booked.

Send the list

More advice

The suburbs

Bluewater Bay, Seaview and Beachview: why a list beats a quick call-out

A single dripping tap is not worth the drive out to Beachview. A list of six jobs is. How north coast visits are planned and what tends to fail there.

Read it

Fittings

Shelves that actually hold: brackets, plaster and the weight question

Almost every shelf failure comes down to the bracket being chosen for the look rather than the wall. How to drill into the wall you actually have.

Read it

Pools

Getting the pool ready for December: the six-week plan

Recovery is a sequence, and it takes weeks because chemistry and filtration work on time. The six-week plan that makes December easy.

Read it

Pools

Pool filter sand and cartridges: the service most pools skip

A pool filter fails so slowly nobody notices until the water never quite clears. The signs, the media types, and what replacing it costs in Gqeberha.

Read it

Rentals

Landlord turnarounds in Lorraine, Framesby and Kabega Park: the punch list that gets the deposit back

The move-out punch list that gets a Gqeberha deposit back: room by room, what counts as wear and tear, the five repairs that cost tenants, and how to time a turnaround.

Read it

Assembly

A wardrobe and a bed, assembled: what breaks and what it costs to put right

A two door wardrobe and a bed base are the two items most often half-assembled. What each costs, the failures that break them, and when to rescue rather than replace.

Read it

Tiling

Tile over tiles or strip first? What each costs in Port Elizabeth

Tiling over an existing floor is faster and cheaper on paper. Here is when it is legitimate, what the height does to doors and skirtings, and what stripping really adds.

Read it

The suburbs

Older homes in Newton Park, Charlo and Mount Croix: the jobs that keep coming back

The older inner suburbs of Port Elizabeth share the same tired fittings. The five jobs that repeat across the area, what each costs, and how to batch them into one visit.

Read it

Plumbing

A toilet that keeps running: what it costs to fix

A running toilet has four causes and a two-minute diagnosis. Which part to replace, what it costs, and when it becomes a plumber's job.

Read it

Assembly

Flat pack assembly: time, tools and the parts that break

What is actually in the box, the tools that matter, where the time goes, and the four failures that turn a one visit job into two in Gqeberha.

Read it

Tiling

Tiling in Port Elizabeth: what it costs per square metre in 2026

The per square metre price is the most quoted number in tiling and the least useful one. Here is what the published ranges cover, and how to get a real figure.

Read it

Pools

Pool pump not working: the eight faults and what each one costs

A pool pump fails in one of three ways: silent, humming, or running without moving water. The two-minute check finds the fault, and each repair is priced per job.

Read it

Areas

A handyman visit in Summerstrand, Walmer and Newton Park

Three suburbs minutes apart, three different kinds of job. What salt air does on the beachfront, what older houses need in the centre, and what a visit covers.

Read it

Painting

Painting touch-ups after a repair: why the patch shows

A touched up patch almost always shows, even when the colour matches. What the wall has done to the old paint, and how far back a repair has to go.

Read it

Roofing

Roof leak repair in Port Elizabeth: what it costs in 2026

Roof work is the least predictable job on any list. What the money actually goes into, and what a leak costs to repair in Gqeberha.

Read it

Waterproofing

Roof waterproofing in Port Elizabeth: priced per job, not per square metre

Why this site prices a waterproofing job rather than a square metre, where tiled roofs actually fail on the coast, and what the work costs.

Read it

Scope

What a handyman can and cannot legally do in South Africa

The one line that decides whether a job is handyman work or a registered trade, and how to read the answer before you book anyone.

Read it

Assembly

Flat pack furniture assembly in Port Elizabeth: what it costs per item

Flat pack furniture is priced per item, not per box. What a bed and a wardrobe cost to assemble in Port Elizabeth, and why a missing fitting stalls the job.

Read it

Doors

Hanging a door in Port Elizabeth: what it costs and what is involved

A door is a slab of timber going into a frame that has had decades to move. What the job actually involves, and what it costs in Gqeberha.

Read it

Leaks

Water coming through the ceiling: what to do in the first hour

What to do in the first hour when water starts coming through a ceiling, why poking the bulge is a mistake, and how the leak is traced back to its actual source.

Read it

Landlords

A rental maintenance checklist for Gqeberha landlords and agents

Running a rental on a checklist instead of on complaints means one planned visit instead of five separate ones. The list, and what it costs.

Read it

Fitting

Curtain rails and blinds in Port Elizabeth: who fits them and what it costs

Shops sell the rail, the blind and the shelf, then leave you to fit them. What fitting costs per window in Port Elizabeth, and why the wall decides the fixing.

Read it

Small plumbing

A dripping tap in Port Elizabeth: what it costs and when it needs a registered plumber

A dripping tap costs you on the water bill and on your sleep. What the repair costs in Port Elizabeth, and where the plumber has to take over.

Read it

TV mounting

TV wall mounting in Port Elizabeth: what it costs and which wall you have

One number decides most of the price before anyone arrives: what your wall is made of. How to check, and what fitting a bracket actually comes to.

Read it

Odd jobs

No job too small: the odd jobs a handyman actually does

The hardest job to get done in a house is never the big one, it is the single small thing. Here is the actual list, and why batching them pays.

Read it

Coastal

Salt air and rust: what coastal Gqeberha does to doors, windows and fittings

Salt air corrodes the fittings that hold a coastal home together. What the sea does to doors, windows and gate hardware in Gqeberha, and what the repairs cost.

Read it

Cupboards

The cupboard hinge that pulled out of the chipboard

Once the screw holes in chipboard strip, tightening the same screw never works again. Here is which repair holds, and what it costs in Gqeberha.

Read it

Pricing

What a handyman costs in Gqeberha

What the common jobs actually cost in Gqeberha in 2026, why an hourly rate is a bad deal for the person paying, and how to judge a quote you have been handed.

Read it

The list

The small-job list: twelve things worth booking in one visit

The jobs that sit on the fridge door for a year. How long each one takes, which ones belong in one visit, and how to split a long list sensibly.

Read it

Complexes

Complex access: what to have ready before a handyman arrives

Access registers, POPIA requirements, noise hours and lift rules. The details that decide whether a booked visit starts on time or stalls at the boom.

Read it

Send the list. Get a price. Get it done.

One or twenty jobs, it makes no difference. The more you put on the list, the better the visit works out.

WhatsApp your listCall 067 397 3341

No price is agreed until you approve it

Call nowGet a quote