Houses in the older inner suburbs of Port Elizabeth were built in a different era of materials and standards, and it shows in a specific set of repairs. Not dramatic damage. Just fittings that have done fifty years of work and are tired in ways that repeat from house to house on the same streets.
If you live in one of these homes, this is likely a list you will recognise, and most of it can be dealt with in a single visit.
What the housing stock does
Three things are shared across most of these homes, and each one causes a different class of repair.
Timber window frames and doors that have moved with the seasons for decades. Frames settle, hinges wear, and a door that fitted perfectly in 1994 now catches on one corner in July and swings free in January.
Cupboards with the original hardware. Older kitchens in this area often have solid carcasses with brass or steel catches, hinges that predate concealed soft close, and doors that have been rehung once already.
Walls and floors that have had water through them at some point. Rising damp at the base of a wall, a bathroom that leaked into the room next door ten years ago, plaster that has been patched by three different people.
Add coastal humidity, which is lower than on the beachfront but still enough to swell timber and lift cheap paint, and the pattern is complete.
The five jobs that repeat
Sticking doors. By far the most common. The cause is usually a hinge that has worn or a frame that has moved slightly out of square, not a door that has grown. Adjusting the hinges is the fix on most of them. Sanding the door is the fix people reach for, and it is why the same door sticks again next winter with a bigger gap in summer.
Cupboard doors that will not stay closed, or that hang at an angle. Usually a hinge that has worked loose from old timber, or a catch that no longer lines up. In the older units the timber is often solid enough for a proper repair rather than a replacement, which is good news.
Loose or stripped hinge screws in door frames. Old timber hardens and screws lose their bite. A move to a longer screw, or a glued plug in the hole, restores it without touching the frame.
Windows that will not close properly, or that let in wind. Sliding sashes and steel frames both suffer here. Sometimes it is a worn catch or a handle mechanism, sometimes it is the frame that has shifted, and the difference decides whether it is a handyman job or a specialist.
Dripping taps and running toilets on old plumbing. The fittings have lasted well, the washers have not.
Why sanding the door makes it worse
This is worth its own section because it is the most common mistake in a house of this age.
A timber door swells in the humid months and shrinks in the dry ones. When it sticks, a person sands the edge until it closes. In the dry months that same door now has a visible gap, so more heat and dust come through. Next winter it swells again, sticks harder, and gets sanded again.
Every cycle takes more off the door and does nothing about the frame. Adjusting the hinge moves the door back to where it belongs and leaves the timber alone. It takes about as long, and it does not cost you a door.
Older electrical work: what to leave alone
A house from this era will usually have had its distribution board updated at some point, and sometimes it has not. If you see a board with ceramic fuses, fabric-covered wiring, or no earth leakage protection, that is the moment to call a registered electrician rather than a handyman.
Anything on a plug circuit, a light fitting change, or a switch replacement needs a certificate of compliance in the end. We do the handyman work around that: fixing what holds the fitting in place, repairing the ceiling rose that the fitting hangs from, dealing with the timber and plaster. The wiring itself belongs to someone registered.
It is one of the ways a handyman saves you money rather than costing you: knowing the line and stopping at it.
Two jobs that look small and are not
The ceiling fitting. Swapping a light fitting looks like a ten minute job and is not one. The old fitting may have been installed onto a timber batten, the ceiling rose may be perished, and the cable may not have enough slack to reach the new terminals. If the plaster around the rose is cracked, or the cable looks fabric covered, the job stops there and an electrician takes over. What we do is make the mounting sound and the ceiling clean, because that is where the visual result comes from.
The window that will not lock. On older aluminium and steel frames, the catch or handle mechanism wears, and a window that does not close properly is both a security problem and a source of wind noise all summer. Replacing a handle is straightforward. Replacing a mechanism on a discontinued frame is a parts question, and it is worth knowing that before the visit rather than during it.
Both of these are the kind of job that gets put off for years. Both are also quick to price once someone has seen them.
What it costs, roughly
Published per job ranges for the common repairs in a house of this age:
- A sticking door, adjusted at the hinges: R280 to R500
- A door planed and refitted: R400 to R650
- Hinges replaced: R200 to R380
- A cupboard door rehung on new hinges: R250 to R500
- A hinge plate pulled out of chipboard, repaired: R300 to R550
- A drawer runner replaced: R300 to R500
- A curtain rail fitted, standard window: R320 to R550
- A floating shelf fitted: R280 to R500
Materials and fittings are quoted separately and approved before anything is bought, which matters in an older house where the right hinge is not always the one on the shelf.
What to book in one visit
These houses reward batching more than newer ones, because most of the faults are small and adjacent. A realistic single visit:
- Two or three sticking doors, adjusted at the hinges.
- Cupboard doors rehung or catches replaced in the kitchen.
- A toilet seat and a dripping tap.
- A curtain rail or shelf that has been waiting since last summer.
- The wardrobe door that came off its runner.
That is a full morning, it is all indoor work, and it does not depend on the weather.
One practical note on batching in an older house: book the doors together rather than one at a time. The second door is always faster than the first, because the same adjustment gets made with the same tools and the same knowledge of how this particular frame has moved. Spread them over three bookings and you pay three times for the same thinking. The price is fixed per job before we start, so you know what the list costs before anyone arrives.
What we need to know when you book
- How many doors are catching, and whether they catch at the top, the side or the bottom.
- Whether the cupboards are original or had new doors at some point.
- The wall type anywhere something is being mounted, because a 1960s plaster wall behaves differently from a modern partition.
- Photos of anything that looks like it might be a bigger problem than it seems. A door frame that is out of square shows up in a photo of the gap.
That is usually enough to bring the right fixings and the right hinges on the first visit, which is where the saving is.
Book the doors and the cupboard work together. The second door is always faster than the first, and the price is fixed per job before we start.
Book it
WhatsApp 067 397 3341 with your list and your suburb. We cover Newton Park, Charlo, Mount Croix, St George's Park, Central, North End, Sidwell, Sydenham, Kensington and Adcockvale, along with the rest of Gqeberha and Port Elizabeth.
Most of the jobs in an older house are small. The trick is putting them in one visit instead of leaving them on the fridge door for another year.
Got a list that needs working through?
Send it on WhatsApp with a photo or two and you get a price back, before anything is booked.
Send the list