A handyman may legally do any repair, fitting, assembly or installation job that does not need a registered practitioner and does not end in a compliance certificate. Everything else follows from that one line. In Gqeberha, and across Port Elizabeth, the great majority of what a home actually needs sits on the safe side of it, and the small number of jobs that do not are easy to recognise once you know what separates them. The boundary is not about difficulty and it is not about the size of the job. It is about who is legally allowed to put a name to the finished work.
The principle, in plain terms
Work that carries a legal requirement for a registered person, or that has to end in a certificate you keep on file, is not handyman work. How small or how quick the job looks does not change that. A short change to a fixed circuit is still electrical work, and a new connection on a water supply line is still plumbing work. Size does not move a job across the line. The test to apply is a simple one. When the work is finished, is somebody supposed to hand you a document? If the answer is yes, it is not a handyman job. If the answer is no, it usually is, and it can be quoted as a fixed price per job before anything starts.
What a handyman may do freely
- Rehanging a door, adjusting a sticking door, replacing worn hinges, and repairing a hinge plate that has pulled out of chipboard
- Replacing a tap washer or a cartridge, a toilet seat, a fill valve or a flush valve
- Fitting TV brackets, floating shelves, curtain rails and blinds, with fixings chosen for the wall they are going into
- Assembling flat pack furniture, bed bases, wardrobes and outdoor sets
- Filling and painting a wall patch, cleaning and repainting skirtings, and redoing silicone around a bath or a basin
- Repairing a single storey tiled roof, including replacing cracked tiles and resealing a flashing or a perished seal
That list is not the whole of it, and it is not meant to be. It is long because the test is generous. If a job can be done properly without a registered person signing it off, it is handyman work, and it can be quoted as a fixed price rather than an open ended arrangement. Materials and fittings sit outside that price, on both sides of the line, and they get approved by you before anything is bought.
The plumbing line
Taps, toilets, washers, cartridges, seats and fill valves are handyman work, and so is redoing silicone, refitting a bath or a basin that has pulled away, and replacing a tired garden tap. Pipework is where it stops. Geysers, buried drainage, and anything on the water supply beyond a fitting itself belong to a registered plumber. So does anything that has to be opened up inside a wall to reach the pipe behind it. This matters most when a simple job turns out to be a larger one. If changing a tap reveals a pipe that has corroded through, the right thing is to stop, show you what has been found, and hand it to a plumber. Carrying on and hoping the repair holds is how a small problem becomes a claim.
The electrical line
Plugs, switches, light fittings and anything that touches fixed wiring are a registered electrician's work. That includes a new socket, a new circuit, a light fitting that has to be wired in rather than plugged in, and any change inside the distribution board. What a handyman can do around electricity is the part that carries no current: mounting a TV bracket, fitting a shelf, hanging a plug in fitting, or replacing a cover plate after the electrician has gone. If a job needs the power off at the board and a wire moved, it is not handyman work. Somebody who offers to do it anyway is telling you something about how carefully the rest of the job will be done.
The roofing line
Roof work is handyman work on a single storey tiled roof, and only there. Replacing cracked tiles, resealing a flashing, sorting a valley where water pools, and tracing a leak back to where it actually gets in are all sensible jobs on that kind of roof. Above one storey, anything needing scaffolding, or any work off a ladder higher than one storey, is referred out. So is the roof structure itself: trusses, purlins and anything load bearing. Ceiling boards that need replacing belong to a ceiling contractor. Nobody should be getting onto a second storey roof to save you a phone call, because the risk taken is not only theirs.
Gas, gate motors and solar
Gas installations and any change to a gas line are not handyman work. Work that has to end in a gas certificate belongs with a registered gas practitioner, and that certificate is the whole point of it. Gate motors and automation are out of scope. A gate that drags, or a bolt, a wheel or a catch that needs attention, can be a handyman job, but the motor, its wiring and its settings are not something to hand to a general repair person. Solar is one job wearing two hats. Mounting panels on a single storey roof can be handyman work. Connecting anything to your electrical system cannot: an inverter tied into the distribution board, a new circuit, or any work inside the board is a registered electrician's job, and it normally ends with a certificate. Ask which half of a solar quote you are looking at, because the two halves are priced very differently.
A boundary is a sign of a professional
It is tempting to read a boundary as somebody who cannot do the work. The opposite is closer to the truth. A tradesperson who knows where their scope ends is telling you that they also know the limits of what they do take on, and that a job will be priced to be finished properly rather than priced to get paid and leave. The alternative is worse. Somebody who says yes to a geyser, a new socket and a gate motor is telling you they will do that work without the certificate that makes it legal. The cost of that does not disappear. It lands on you later, usually when a property is being sold or a claim is being made.
When your job sits on the line
- Photograph the job and send it on WhatsApp with a plain description of what you want done
- You get told straight away whether it is handyman work, and if it is not, which trade it needs
- Where a job has two halves, such as solar or a repair that exposes pipework, the halves get separated before anything is booked
- If a job opens up into one of those areas once work has started, work stops and you are told before anything else happens
- No certificate is offered for work outside this scope, because it cannot be
The easiest way to hold the whole thing in your head: if the finished job is supposed to end with a document in your hand, it is not handyman work. No document, no boundary, and it becomes a job that can be quoted as a fixed price.
The short version
Handyman work is anything that does not need a registered practitioner or a certificate: doors, cupboards, shelves, taps, toilets, TV brackets, furniture assembly, small repairs to a single storey tiled roof, patching, silicone and painting touch ups. Pipework beyond a fitting, fixed electrical work, second storey roofs, roof structure, gas work and gate automation are not.
If you are not sure which side your job falls on, send a photo and a short description on WhatsApp. You get a fixed price back if it is handyman work, and a straight answer about who to call if it is not.
Got a list that needs working through?
Send it on WhatsApp with a photo or two and you get a price back, before anything is booked.
Send the list